as the temperature of the water gets colder, the speed of its molecules:

Answer:

The correct answer is "wave B has a lower frequency."

Explanation:

The Doppler effect is defined as the change in apparent frequency of a wave produced by the relative movement of the source with respect to its observer. In other words, this effect is the change in the perceived frequency of any wave movement when the sender and the receiver, or observer, move relative to each other.

This is the effect that occurs in this case. And it is explained as follows: When the ambulance approaches the observer, the wave "compresses", that is, the wavelength is short, the frequency high and, therefore, the tone of the perceived sound will be sharp. On the other hand, when the ambulance moves away from the observer, the wave "decompresses", that is, the wavelength is long and the frequency low.

Then the correct answer is "wave B has a lower frequency."

Plate tectonics theory describes the motion of the Earth's lithosphere, which leads to geological phenomena such as earthquakes, volcanic eruptions, and mountain building.

Understanding Plate Tectonics

Plate tectonics is the scientific theory that explains the movement of the Earth's lithosphere, which is divided into tectonic plates. The mantle's slow motion drives the movement of these plates, leading to various geological phenomena. Tectonic plates move in different directions causing continents to gradually drift, leading to the formation of mountains, as well as causing earthquakes, and volcanic eruptions. This process is a fundamental aspect of geology and the formation of the Earth's topography. Moreover, plate tectonics acts as a heat distribution mechanism, cooling the planet by transferring heat from the interior to the surface.

Phenomena Caused by Plate Movement

Volcanic eruptions: Happen when molten rock from beneath the Earth's crust escapes through weaknesses in the crust, often at plate boundaries.

Mountain building: Occurs when tectonic plates collide and the land is pushed upwards.

All of these geological events showcase the dynamic nature of our planet, shaped significantly by the underlying movements of its tectonic plates.

The net force on each charge due to the other two can be calculated using Coulomb's Law. The net force on the +75μC charge is 0.263 N in the positive x-direction, and the net force on the -85μC charge is -0.263 N in the negative x-direction.

To calculate the net force on each charge due to the other two, we can use the formula for the electric force between two charges: F = k x q1 x q2 / r2, where F is the net force, k is the Coulomb's constant (9 x 109 N m2/C2), q1 and q2 are the charges, and r is the distance between the charges.

Let's calculate the net force on the +75μC charge due to the +48μC and -85μC charges. The distance between the +75μC charge and the +48μC charge is 0.35 m. Substituting these values into the formula, we get F1 = (9 x 109 N m2/C2) x (75 x 10-6 C) x (48 x 10-6 C) / (0.35 m)2 = 0.263 N.

The net force on the -85μC charge due to the +75μC and +48μC charges is the same as the net force on the +75μC charge, but in the opposite direction, giving us: F2 = -0.263 N.

Therefore, the net force on the +75μC charge is 0.263 N in the positive x-direction, and the net force on the -85μC charge is -0.263 N in the negative x-direction.

https://brainly.com/question/20935307

#SPJ12

The difference between the positions of these two poles when viewed at different locations is defined as the magnetic declination which allows these angles for navigators to determine their true geographic position.

Magnetic declination is also known as magnetic variation. It is the angle on the horizontal plane between magnetic north and true north which varies depending on the position on the Earth's surface and changes over time.

Declination is positive when the angle is east of true north and negative when it is west. It changes over time and with place.

Magnetic declination is caused by the complex shape of the Earth's magnetic field which defines to the use of a compass with its needle pointing north for navigation.

Thus, the difference between the positions of these two poles when viewed at different locations is defined as the magnetic declination which allows these angles for navigators to determine their true geographic position.

Learn more about Magnetic Declination, here:

https://brainly.com/question/14071370

#SPJ3

Specific gravity = Density of an object/Density of water

Density = Mass/Volume

For the current scenario;

Density of halite = mass/(l*w*h) = 58.75/(3.18*3.06*2.79) = 58.75/27.148932 = 2.164 g/cm^3

Density of water ≈ 1000 kg/m^3 = 1 g/cm^3

Answer:

Explanation:

Final answer:

To find acceleration with mass, coefficient of friction, and applied force, we can use Newton's second law and the formula for frictional force. The applied force can be calculated by subtracting the force of friction from the net force.

Explanation:

To find acceleration with mass, coefficient of friction, and applied force, we can start with Newton's second law. Newton's second law states that the net force on an object is equal to the mass of the object multiplied by its acceleration: F_net = m * a. In the case of friction, we can use the formula for frictional force: F_friction = µ * N, where µ is the coefficient of friction and N is the normal force.

The normal force can be calculated as the product of mass and acceleration due to gravity: N = m * g. The applied force can be calculated by subtracting the force of friction from the net force: F_net - F_friction = F_applied.

Answer:

Option (A)

Explanation:

The asteroids are the rocky materials that are present abundantly in space. They are found primarily in the asteroid belt where there are millions of asteroids and frequent collision takes place in this belt. These asteroids revolves around the sun. These asteroids are of various sizes, ranging from small pieces into large mass that can cause tremendous effect to earth. These asteroids are the left overs of the early solar system, which got scattered in space soon after the formation of the universe.

Thus, the correct answer is option (A).

The frequency of light with a wavelength of 725 nanometers is approximately 4.14 × 10^14 Hz, which is calculated using the formula for the relationship between the speed of light, wavelength, and frequency.

The frequency of light can be calculated using the equation c = fλ, where 'c' is the speed of light, 'f' is the frequency, and 'λ' is the wavelength. The speed of light (c) is approximately 3.00 × 108 m/s. So, if the light has a wavelength of 725 nm (or 725 × 10-9 m, to convert nanometers to meters), the equation can be rearranged to solve for frequency (f): f = c/λ.

Substituting the given values, then we get: f = (3.00 × 108 m/s) / (725 × 10-9 m) = 4.14 × 1014 Hz. Therefore, the frequency of light with a wavelength of 725 nm is approximately 4.14 × 1014 Hz.

https://brainly.com/question/10732947

#SPJ2

Answer:

A. There is an overall release of energy when bonds form.

Explanation:

There is a general release of energy when bonds form. This energy is called bond energy.

Bond energy is involved in the breakdown or formation of one or more bonds between atoms of a molecule. Atoms bond with each other to achieve their electronic stability, that is, they move from a higher energy situation to a lower energy one. With this we can state that when the bond between atoms is formed, energy is released; therefore, its breakdown depends on energy absorption.

Answer: 3.2

Explanation:

pH is the measure of acidity or alkalinity of a solution.

pH is calculated by taking negative logarithm of hydrogen ion concentration.

[tex]pH=-\log [H_3O^+][/tex]

[tex]pH=log\frac {1}{H_3O^+}[/tex]

Thus as pH and [tex]H^+[/tex] are inversely related, a solution having lower pH will have more amount of [tex]H^+[/tex] concentration. And a solution having more pH will have less amount of [tex]H^+[/tex] concentration.

Thus the solution with lowest pH of 3.2 will have highest hydronium ion concentration.

Answer:

1. They’re invisible - Radio waves

2. They have colors - Visible

3. They’re used to learn about dust and gas clouds. - Both

4. They can travel in a vacuum. - Both

5. They’re used to find the temperature of stars. - Visible

6. They have energy. - Both

Explanation:

The magnetic spectrum consists invisible and visible part of the spectrum. The invisible part consists of radio waves. These are waves used for radios, tvs, and cellphone communications. They satisfy all the properties of transverse waves.

The visible part comes from light. This is the part that is visible to the naked eye. Examples are ultraviolet rays, the sun, neon lights etc. To determine how hot something is, the visible portion is used. The brighter the object, the hotter it is.  Thus, the brightness of the stars can be determined by the color of the light emitted. The visible rays satisfy all the properties of transverse waves. However, light is considered a dual nature - it has wave and electron-like properties.

Answer:

A/ Elastic potential energy changes to gravitational potential energy

Explanation:

just took the test

Answer:

a

Explanation:

i got it right on edg

No, actually the answer is atoms.

Answer:

4.9

Explanation:

ecad

Answer: The right answer is C interference.

Explanation: Two slightly out of tune instruments will create beats when the same note is played. This is a pattern of louder and softer sounds. A piano tuner uses this method to tune a piano. When two waves overlap, they each act as if the other is not there. This interaction is known as A) diffraction. B) dispersion. C) interference. D) refraction.

Final answer:

To find the two sets of consecutive integers that satisfy the given property, we can set up and solve an equation. The equation is (x+1)(x+2) = 7x - 1. Solving this equation, we find two possible values for x: 1 and 3. Substituting these values, we find the two sets: {1, 2, 3} and {3, 4, 5}.

Explanation:

To find the two sets of consecutive integers, let's assign variables to the smallest integer in each set. Let's say the first set starts with x, so the consecutive integers in that set would be x, x+1, and x+2. Similarly, let's say the second set starts with y, so the consecutive integers in that set would be y, y+1, and y+2.

According to the given property, the product of the larger two integers (in this case, (x+1)(x+2)) is one less than seven times the smallest integer (in this case, 7x-1).

We can now form an equation: (x+1)(x+2) = 7x - 1.

To solve this equation, we can expand the left side and then simplify:

x^2 + 3x + 2 = 7x - 1

x^2 - 4x + 3 = 0

Now, we can factor the quadratic equation:

(x - 1)(x - 3) = 0

So the possible values for x are 1 and 3. Substituting these values back into the original equations, we can find the two sets of consecutive integers:

For x = 1, the integers are 1, 2, 3. And for x = 3, the integers are 3, 4, 5.

Therefore, the two sets of consecutive integers that satisfy the given property are {1, 2, 3} and {3, 4, 5}.

Answer:

The Ileum connects the small intestine, and the large intestine.

Explanation:

The ileum is the last section of the small intestine. And it leads to the large intestine. The ileum mainly absorbs water, bile salts, and vitamin B12. The ileocecal valve is a one-way valve located between the ileum and the cecum, (which is the first portion of the colon.)

Answer:

the correct answer is "c"

Explanation:

i took the test on usatestprep the answer is c (The particles will experience a repulsive force that will drive them apart along the line joining their centers.)