it decreases by a factor of 2
In a series circuit, the resistors are arranged in a series and where, the current is inversely proportional to the resistance. Thus when resistance is increased to 6 ohm current will decreases to half.
What is resistance?Resistance is a physical quantity and is the measure of resistance to the current. It has a unit called Ohm. The device which is used to measure the resistance in a circuit is called a resistor.
According to Ohm's law, the product of current and resistance in a circuit is the voltage or potential difference in the circuit V.
I.e., V = I R.
As per this relation it is clear that the resistance and current in a circuit are in inverse proportionality. Therefore we have the equation relation them as:
I1/ I2 = R2/ R1
It is given that the initial resistance of 3 ohm increased to 6 ohm. Thus current will decrease there to half since resistance is increase to double.
Therefore, current will reduces to half of its initial value.
To find more about resistance, refer the link below:
https://brainly.com/question/14547003
#SPJ5
Four beats per second are heard when an unknown tuning fork and a 240 Hz tuning fork are struck simultaneously. This same unknown tuning fork and a 250 Hz tuning fork are struck. Six beats are heard. Its exact frequency?
What does this graph show about the relationship between mass and acceleration? As acceleration increases, mass increases. As acceleration increases, mass is unaffected. As mass is unaffected, acceleration decreases. As mass increases, acceleration decreases.
Your car burns mostly octane, c8h18, as a fuel. how many liters of oxygen are needed to burn a kilogram of octane
Answer:
2.5 litres
Explanation:
First, let us write the balanced chemical reaction of the reaction going on in the internal combustion engine. The balanced equation is given in the reaction below;
2 C8H18 + 25 O2 -----------> 16CO2 + 18 H2O. ------------------------------------(1).
OR
C8H18 + 12.5 O2 ---------------->8CO2 + 9 H2O. ------------------------(2).
From the equation of reaction above, we can see that one mole of C8H18 reacts with 12.5 moles of O2 to give 9 moles of water and 8 moles of Carbondioxide, CO2.
Hence, in one Kilogram, that is 1000 grams, we are to calculate how many liters of oxygen are needed.
So, the molar mass of C8H18 is 114 grams per mole(that is; 12×8 + 1×18).
We have to calculate the number of moles using the formula below;
Number of moles,n= mass/molar mass.---------------------------------------(3).
Number of moles,n= 1000 gram/ 114 gram per mol.
Number of moles,n= 8.8 moles.
Thus, 12.5 moles of oxygen reacting and the number of moles of oxygen needed is (12.5 × 8.8 ) moles = 110 moles.
The volume of litres of oxygen needed= 110 moles × 22.4 dm^3.
===> 2464 dm^3.
==> 2.5 litres of oxygen is needed.
Multiplying or dividing vectors by scalars results in a. vectors. b. scalars. c. vectors if multiplied or scalars if divided. d. scalars if multiplied or vectors if divided.
The correct answer is option A: Vectors
When a vector is multiplied or divided by a scalar, the result is still a vector.
A vector is any quantity that has both magnitude and direction while a scalar is a quantity that can only be described completely by its magnitude without direction.
Hence, when a vector is multiplied or divided by a scalar, the result is still a vector because the operation only acts on the magnitude and not the direction of the vector.
However, a vector can not be divided by another vector .
https://brainly.com/question/13012190
The moon most likely formed
A. From a collision of Earth with a Mars-sized object.
B. In another region of space and drifted toward Earth.
C. From material in the solar system that came together.
D. In the same way as Earth formed.
Yor older sister drove 500 miles to college one way in ten hours. what is her average velocity?
Final answer:
To calculate the average velocity, which in this context is the average speed due to lack of a specified direction, divide the distance by the time. For your sister's trip, it would be 50 miles per hour.
Explanation:
Your older sister drove 500 miles to college in ten hours. To calculate her average velocity, you simply divide the total distance traveled by the time it took to travel that distance. Average velocity is a vector quantity, which means it includes both magnitude (how fast) and direction, however, if only the distance and time are known, and the direction is not specified, people often refer to the magnitude part of velocity simply as speed.
Formula to calculate average velocity (speed in this context) is:
Average Velocity = Total Distance Traveled / Total Time Taken
Plugging in the numbers:
Average Velocity = 500 miles / 10 hours = 50 miles per hour
So, her average speed would be 50 miles per hour.
a person standing in the ocean notices that after a wave crest passes by ten more crest pass in a time of 120s what is the frequency
How long does it take if a snail was to travil a distance of 3 ft at 0.1 ft/sec?
Which of the following is the correct formula for calculating power
A. P= F/W
B. P= W x F
C. P= t x F
D. W/t
Which planet might best be described as a large dirty ice ball?
The planet that is BEST described as a dirty ice ball would be the planet Pluto
hope this helps
The electric current running through the wire coil in an electric motor exerts force directly onto
Answer: C
a powerful magnet
Explanation:
its the correct answer
Usain bolt can run the 100 m dash in 9.58 s. what is usain's average acceleration during this sprint?
This is the method by which a wave travels through a medium or a vacuum.
the atomic mass is important because?
a. it tells you the size of the atom
b.it tells you the number of electrons
I have 2 questions
1.How does your ear drums feel when u dive deep into a swimming pool?
2. why does your ear hurt when under water ?
(This is related to fluid pressure)
Underwater, the pressure increases and pushes against your eardrums, causing discomfort or pain. This feeling, known as barotrauma, arises due to the difference in pressure between the outer part of the eardrum in contact with the water and the inner part in contact with the air.
Explanation:When you dive deep into a swimming pool, the pressure of the water increases. This increased pressure pushes against your ear drum, or tympanic membrane, potentially causing discomfort or pain. This phenomenon is related to the physics of fluid pressure: the deeper you go underwater, the more fluid is above you, and thus the greater the pressure exerted on your body, including your eardrums.
The feeling of ear pain underwater arises due to the imbalance caused by water pressure especially when we aren't able to equalize the difference in pressure between the outer part of the eardrum (in contact with the water) and the inner part (in contact with the air in the middle ear), thus leading to that uncomfortable feeling known as barotrauma.
Learn more about Fluid Pressure here:https://brainly.com/question/29039042
#SPJ12
Can someone explain to me #4.
Carter pushes a bag full of basketball jerseys across the gym floor. The bag weighs 21 newtons. If he pushes the bag 9 meters in 3 seconds, how much power does he use? (Hint: 1 watt = 1 .)
A rod made up of a single element is used to heat water using electricity. To which group does this element probably belong to?
Final answer:
The element in a heating rod that heats water through electricity likely belongs to the group of metals or alloys that are good conductors of heat and electricity. The resistance these metals or alloys offer to electric current results in heating, which converts electric energy into the thermal energy used to heat the water.
Explanation:
The element used in a heating rod to heat water through electricity likely belongs to the category of metals or sometimes alloys with high resistance, such as a mixture of nickel and chrome. These materials are chosen because they are good conductors of heat and electricity, and they resist the flow of electric current to a certain degree, which causes them to heat up. This resistance effectively transforms the electric energy into thermal energy that heats the water.
As for the input energy in this system, it is the electrical energy provided by plugging in and switching on the kettle. The electricity is the source of energy that, due to resistance within the metal coil or heating element, is converted into heat which in turn increases the temperature of the water.
In Milgram's experiment:
A. the "learner" sometimes had lasting injuries.
B. two-thirds of people refused to participate.
C. almost no one went to 450 volts.
D. almost two-thirds of participants went all the way to 450 volts.
In Milgram's experiment: Almost two-thirds of participants went all the way to 450 volts. (option D)
What is Milgram's experiment?In Milgram's experiment on obedience, participants were instructed to administer electric shocks to a "learner" (a confederate) whenever they answered questions incorrectly.
Contrary to expectations, almost two-thirds of the participants continued to administer shocks up to the maximum voltage of 450 volts, despite the learner's apparent distress.
This shocking result revealed the extent to which people can follow authority figures, even when it involves causing harm to others, highlighting the power of social influence and obedience.
learn more about Milgram's experiment from
https://brainly.com/question/9791509
#SPJ3
What is the density of a rock that has a mass of 10 grams and the volume of 2ml?
Velocity is the change of speed and/or direction of An object true or false
The energy gained by electrons as they are accelerated by an electric field is
A violin string playing the note "a" oscillates at 440 hz. what is the period of the string's oscillation? answer in units of s.
Answer:
0.002272727
Explanation:
1/440= 0.002272727
if energy is absorbed because of a chemical reaction the reaction is ____. a product, exothermic, limiting, endothermic.
If energy is absorbed because of a chemical reaction the reaction is Endothermic.
Answer: Option D
Explanation:
There are two types of chemical reaction depending upon whether the energy is absorbed or released to the surroundings. When the energy is absorbed in a reaction from the surroundings it is called as an endothermic reaction and the temperature of the surroundings gets affected.
When the opposite reaction occurs in the surroundings, it is called as an exothermic reaction. Option A and B are irrelevant to the situation here. So if the energy is absorbed because of a chemical reaction then the reaction is said to be endothermic.
Abdul has not eaten in a while, so his endocrine system releases hormones that slow the process of digestion, which in turn slows the production of materials for new cells. What process in Abdul is being regulated by hormones?
metabolism. when you do not eat, your body's metabolism is put off.
What type of energy transfer mechanism needs no medium to travel through?
Which lens can produce a virtual image and a real image?
concave lens
convex lens
flat lens
A convex lens can produce both real and virtual images, depending on the object's position relative to its focal point. Concave lenses only form virtual images, and flat lenses don't produce any focused images.
Explanation:The convex lens is capable of producing both real and virtual images. This is because a convex lens converges light rays. When the object is placed at a position beyond the focal point of the lens, a real, inverted image is formed. A virtual image is formed when the rays of light appear to be coming from a point behind the lens, whereas a real image is formed when the rays of light converge and meet at a point in front of the lens.
In the case of a convex lens, a virtual image is formed when the object is located between the focal point and the lens, and a real image is formed when the object is located beyond the focal point.
However, when the object is positioned within the focal point, the lens creates a virtual, upright image. On the contrary, a concave lens can only produce virtual images, while a flat lens cannot produce any focused image.
Learn more about Lens here:https://brainly.com/question/34820217
#SPJ12
A convex lens can produce both real and virtual images; concave lenses can only form virtual images. A real image is inverted and formed outside the focal length, whereas a virtual image is upright and formed within the focal length.
In answering the question about which lens can produce both a virtual and real image, we focus on the types of lenses: concave, convex, and flat. Out of these, the convex lens (also known as a converging lens) can form both real and virtual images. A real image is formed when the object is placed outside the focal length of the convex lens, and it is inverted. A virtual image is formed when the object is within the focal length of the lens, and it is upright and cannot be projected onto a screen. In contrast, a concave (diverging) lens can only produce virtual images, and flat lenses typically do not produce either type of image in the same manner as curved lenses.
Which section of the reaction represents the reactants? A) a B) b C) c D) d
Answer:A
Explanation:
1. How will the ice water mix with the salty water? Write your hypothesis below.
Answer: If the ice is mixed in with the salty water then, the ice will melt slower
Explanation:
The application of salt actually causes ice to melt because a solution of water as well as disbanded salt has a lower freezing point than pure water.
What is freezing point?The temperature at which water freezes is referred to as the freezing point. When discussing the weather, the term "freezing point" is frequently used.
Throughout the day, the temperature remained below freezing. A substance's freezing point is the temperature at which it freezes.
A melting point is the temperature at which a solid transforms into a liquid under normal atmospheric pressure.
Melting is actually slowed in a salty liquid because the cold melted water sits on top of the denser salty water. This prevents heat from rapidly reaching the ice.
The implementation of salt causes severe ice to melt because a solution of water and dissolved salt does have a lower freezing point than distilled water.
When ice comes into contact with salty water, it melts, releasing more liquid water, which dissolves more salt, causing more ice to melt, and so on.
Thus, this way salt acts on the ice.
For more details regarding freezing point, visit:
https://brainly.com/question/3121416
#SPJ2
You can see a clock in a spaceship moving past you at 90 percent of the speed of light. according to you, how much time would pass while the clock in the spaceship ticked through one minute?