An experiment yielded the above temperature and time information. what is the freezing point of the material in this experiment if the material is a solid at time zero?

B) electrical safety outlet that monitors current flowing to and from an appliance.

A GFCI should be used in any indoor or outdoor area where water may come into contact with electrical products.

The GFCIs be used in all kitchens, bathrooms, garages, and outdoors.

Here,

A ground-fault circuit interrupter is an electrical safety outlet that monitors current flowing to and from an appliance.

The ground-fault circuit interrupter, or GFCI,

It is a fast acting circuit breaker designed to shut off electric power in the event of a ground-fault within as little as 1/40 of a second.

It works by comparing the amount of current going to and returning from equipment along the circuit conductors.

Therefore,

A ground-fault circuit interrupter is an electrical safety outlet that monitors current flowing to and from an appliance.

Learn more about Ground fault circuit interrupter here:

https://brainly.com/question/1873575

#SPJ2

answer BBBBBBBBBBBB on EDGE

Answer:

a larger current in the opposite direction

Explanation:

As we know by Faraday's law of electromagnetic induction that rate of change in magnetic flux will induce electric current in a conducting coil linked with it

so it is given as

[tex]EMF = \frac{d\phi}{dt}[/tex]

now in this situation we know that first a magnet is entering into the coil so here the magnetic flux is increasing linked with the solenoid coil.

So it will induce some current in the coil which shows deflection in galvanometer coil.

Now when we pull the magnet out then it will decrease the flux linked with the coil so here the direction of induced current must have to decrease.

Also it is given that coil is removed at faster rate due to which the rate of change in flux will be more so here it will induce more current

so correct answer would be

a larger current in the opposite direction

The correct choice is Buffers.

Buffers contains both acids and bases in equilibrium.when base is added to buffers, they adjust the pH value by releasing hydrogen ions.when acid is added to buffers, they adjust the pH value by consuming hydrogen ions. hence these substances resist any change in their pH value by releasing or absorbing hydrogen ions.This process keeps the pH value constant.

Final answer:

The distance light travels in the time it takes sound to travel 1 cm in air at 20°C is approximately 8.75 × 10^5 cm.

Explanation:

The speed of sound in air can be approximated using the formula v = 331.4 m/s + 0.6T, where T is the temperature of the air in Celsius. At 20°C, the speed of sound is approximately 343 m/s. To find the distance light travels in the time it takes sound to travel 1 cm in air at 20°C, we can set up a proportion.

If sound travels 1 cm in air at a speed of 343 m/s, we can set up the following proportion:

343 m/s / 1 cm = c / x

where c is the speed of light and x is the distance light travels in the same time. Solving for x, we find:

x = (1 cm) * (c / 343 m/s)

Substituting the speed of light c = 3.0 × 10^8 m/s, we can calculate the distance light travels:

x = (1 cm) * (3.0 × 10^8 m/s / 343 m/s)

x ≈ 8.75 × 10^5 cm

Final answer:

The tension in the rope is 516 N.

Explanation:

To find the tension in the rope, we need to calculate the net force acting on the sled. The net force is equal to the mass of the sled multiplied by its acceleration. Given that the sled has a mass of 72 kg and accelerates at 2 m/s² for 5 seconds, we can use the equation:

Net force = mass x acceleration

Net force = 72 kg x 2 m/s² = 144 N

However, there are two forces acting in the opposite direction - the force of friction (120 N backwards) and the drag force (540 N backwards). So, the net force is:

Net force = 144 N - 120 N - 540 N = -516 N

The negative sign indicates that the net force is acting in the opposite direction of motion. Therefore, the tension in the rope is equal in magnitude and opposite in direction to the net force, so the tension in the rope is 516 N.

Answer:

b. False

Explanation:

An object that is behind you, is not in your cone of vision, since your cone of vision, is an imaginary cone that projects from your eyes foward, approximate 60-degree angle straight foward. The cone of vision is the area of sight.

As you can not see behind you, an object behind you, is not in your cone of vision.

Answer:

m=40.8km.

Explanation:

T

1

=

1

=80Hz

The basic relationship bet

where

\lambdaλ is the wavelength of the wave

v is its speed

f is its frequency

If we plug the numbers given by the problem into this equation, we can find the wavelength of this wave:

\lambda= \frac{v}{f}= \frac{3.26 \cdot 10^6 m/s}{80 Hz}=4.08 \cdot 10^4 m=40.8 kmλ=

f v

=

80Hz

3.26⋅10

6

m/s

=4.08⋅10

4

m=40.8km

high energy photons have high frequencies hope this helps brother

Answer:

Conductors allow electric charges to move freely

Answer:

Gravity

Explanation:

The weight of a person is given by :

W = m g

Where

m is the mass of the person

g is acceleration due to gravity.

Weight of the person depend on the value of acceleration due to gravity. The mass of the person remains the same in every location. On the surface of earth it is equal to 9.8 m/s². While on surface of sun it is equal to 274 m/s².

Hence, a person on earth would weigh a lot more on the sun due to increased gravity.

Answer : Option C) Heredity; Lifestyle.

Explanation : While some aspects are based on heredity, body composition is largely a result of Lifestyle.

Even though it is believed that 80 percent of the aspects of a human body is heredity, but an individual body composition is largely influenced by the result of the lifestyle an individual lives.

In the reaction, Zn(s) + S(s) -> ZnS(s), Zinc (Zn) and Sulfur (S) are the reactants and Zinc Sulfide (ZnS) is the product. This type of reaction is known as a combination or synthesis reaction.

In a chemical reaction, substances that interact are called reactants, and the newly formed substances are called products. In the reaction you have given, Zn(s) + S(s) -> ZnS(s), the reactants are zinc (Zn) and sulfur (S), and the product formed is zinc sulfide (ZnS). This type of reaction is a synthesis or combination reaction wherein two or more simple substances combine to form a more complex substance. It's important to note that in this reaction, Zn and S are in their elemental forms and the reaction represents the process of sulfide mineral formation.

https://brainly.com/question/34137415

#SPJ12

In the reaction Zn(s) + S(s) → ZnS(s), the reactants are zinc (Zn) and sulfur (S), both in solid form. The product is zinc sulfide (ZnS), also in solid form. This is a synthesis reaction where the elements combine to form a single compound.

Reactants and Product of Zn(s) + S(s) → ZnS(s)

In the chemical reaction Zn(s) + S(s) → ZnS(s), the reactants are zinc (Zn) and sulfur (S), both in their solid forms. The product of this reaction is zinc sulfide (ZnS), which is also in the solid state. Here is the step-by-step identification:

Reactants: Zinc (Zn) and Sulfur (S)

Product: Zinc Sulfide (ZnS)

This reaction is an example of a synthesis reaction, where two or more elements combine to form a single compound.

The correct current value is 1.35 A.

The correct current value in the 0.5 dcma position can be determined using the given information. According to the information provided in the question, after 5.00 ms, the current declines to 0.368 of the initial value at t=0. Therefore, we can find the initial value of the current by dividing the value at t=5.00 ms by 0.368. Let's calculate:

Initial current = (0.368)(3.68 A) = 1.35 A

So, the correct current value if the selector is in the 0.5 dcma position is 1.35 A.

A gas does work by changing its volume, adhering to the law of conservation of energy and resulting in increases in energy, pressure, and/or temperature.

A gas can do work by changing its volume. When a gas in a cylinder expands, it exerts a force on the piston and moves it, doing work. According to the Ideal Gas Law, work done by a gas results in an increase in its energy, which can manifest as an increased internal kinetic energy due to the motion of its atoms and molecules. This concept adheres to the law of conservation of energy, meaning that energy within a closed system is neither created nor destroyed, but can change forms. An example of work being done by a gas is when you inflate a bicycle tire; the air pressure and temperature increase inside the tire due to the work done by the pump.

Thus, the correct answer to how a gas does work is A. By changing volume.

Answer:

C

Explanation:

Just took test

According to Charles's law, the volume of a fixed amount of gas is directly proportional to its Kelvin temperature, assuming constant pressure. It means that volume of the gas increases with increase in temperature and decreases with decrease in temperature.

According to Charles's law, the volume of a fixed amount of gas is directly proportional to its Kelvin temperature when the pressure is held constant. This law was named after the French scientist Jacques Alexandre César Charles, a pioneer in balloon flight. It essentially means that when the temperature of gas increases under constant pressure, the volume of the gas also increases and vice versa.

For instance, if you raise the gas temperature from 283 K to 303 K at a constant pressure, you will see an increase in its volume from 0.300 L to 0.321 L, corroborating Charles's law.

https://brainly.com/question/16927784

#SPJ3

Answer:

10

Explanation: